Custom Battery Packs for GPS Trackers and IoT Devices
Choosing a battery for a GPS tracker starts with two measurements: how much energy the device uses between charges and how much current it draws during a transmission. Send Koxin both figures, together with the space available inside the housing, for a small-batch OEM configuration review.
Define a typical day of operation
List sleep, location acquisition, radio transmission and any retry periods. Give the current and time spent in each mode. If the measurements are at the battery input, daily consumption in mAh is the sum of current in mA multiplied by hours in each mode. If measured on a regulated device rail, share its voltage and converter efficiency so the load can be referred back to the battery.
For example, a hypothetical tracker drawing 1mA for 23.9 hours and 100mA for 0.1 hour uses 33.9mAh in that day. This calculation describes average demand. To evaluate startup and radio bursts, send the measured peak, pulse duration and repetition rate, including poor-signal retries. Actual runtime also depends on temperature, cutoff, aging and usable capacity.
Compare two single-cell pouch configurations
Both options below have a nominal voltage of 3.7V. They are candidates for evaluation in a compatible device. Confirm the host charging profile, connector, load and mounting clearance before choosing a sample.
- 1050mAh LiPo with NTC. The three-wire version provides a temperature-sensing lead. Its 3.15A figure is a cell rating. Request the assembled-pack pulse limit, pinout and confirmed drawing before freezing your housing design.
- 1200mAh protected LiPo. This version has two leads and an initial maximum pack envelope of 10 × 30.5 × 42.5mm. Check thickness allowance over service life and specify the mating connector. Confirm pack performance at your actual pulse load.
What should we check during the pilot?
Record battery voltage at the device during startup and radio transmission, especially near your device cutoff. Test in the final housing at the intended operating temperatures. Check whether the host reads the temperature sensor and how it controls charging. Include the mounting method and lead exit in your drawing so the pouch, board and wires have sufficient clearance.
Questions from a hardware team
Can we choose the battery by target runtime alone?
Runtime helps estimate energy. The battery, protection circuit and wiring must also support the measured pulses without excessive voltage drop or a protection trip. Supply a current trace if available.
What if our prototype does not have a final load profile?
Share the device voltage range, available space, best estimate of peak current, sample quantity and the measurements still pending. We can identify which values need validation before a production quote.
What should we send for a US pilot order?
Include sample and pilot quantities, delivery location, target date, charger details and the documents your team requires. MOQ and testing scope depend on the final configuration. Sample fees and any credit toward production are agreed with the quotation.
Request a GPS or IoT battery review
Discuss your tracker on WhatsApp or use the inquiry form below. For a drawing or current trace, mention the file in your message so we can arrange its transfer.
Prepare a battery pack RFQ · Compare lithium-polymer configurations
Send an inquiry
Start a conversation on WhatsApp. Your message will include the product or page you are viewing.
Discuss your requirements on WhatsApp